Price Listing >>

• Frequency Range 20 Hz to 1 MHz
• 0.1% Basic Measurement Accuracy
• Measurement Speeds Up to 40/sec
• 20 Measurement Parameters
• DC Resistance Measurements
• Monitoring of DUT Voltage and Current
• 5 Digit Measurement Resolution
• Constant Voltage (Voltage Leveling)
• GPIB, RS-232 & Handler Interfaces, all Standard
• Open/Short Zeroing & Cable Compensation
• Load Correction
• 14 Pass/Fail Bins
• Keypad Lockout

20 Measurement Parameters
Measure and display any two of 15 impedance parameters simultaneously, with a basic accuracy of 0.1%. Additionally the 1910 can measure the DC resistance, or display the current through or voltage across a test device ensuring the operator of the real test conditions.

Wide Frequency
Over 27,000 user programmable test frequencies to fully characterize devices over the range of 20 Hz to 1 MHz.

Automatic Test Sequencing
For increased productivity and throughput the 1910 can perform up to six different tests in sequence with a single push of the start button. Each test can have different measurement parameters, test conditions and limits.

DC Current Bias
The instruments programmable internal DC bias current source from 1 mA to 1 Amp allows components to be tested under real operating conditions. This can be expanded to 100 Amps when the 1910 is used in conjunction with the QuadTech Model 1320 Bias Current Source and slave units are run the same way every time.

Load Correction
Substantially improves instrument accuracy by allowing the operator to specify the value of a known standard, measure it, and apply a correction to ongoing measurements.

Programmable Source Impedance
The operator is able to set instrument source impedance at 5, 25, 50 or 100 ohms, an important feature when comparing measurements to those made on other another testers. Measurement results can vary substantially based solely on the source impedance of the tester being used.

Includes power cord, instruction manual, and calibration certificate. One year warranty.