|
To order, call us at 800-950-3457 or visit us on the web: www.TestEquity.com |
QuadTech 1920 LCR Meter |
|
|
|
The 1920 is a high performance
LCR Meter designed to perform fast, automated impedance measurements on a variety
of electronic components and materials. The instrument has a basic accuracy
specification of 0.1% for accurate test results over a wide frequency range,
from 20 Hz to 1 MHz. Besides 15 impedance parameters the 1920 is also capable
of measuring DC resistance as well as monitoring the voltage across or current
through the device under test. The unit incorporates a distinctive sequence
test mode, allowing up to 6 uniquely different tests to be performed quickly
on a single start command. Additionally, the 1920 includes GPIB, RS-232, and
handler interfaces, all standard. 20 Measurement Parameters Measure and display any two of 15 impedance parameters simultaneously, with a basic accuracy of 0.1%. Additionally the 1920 can measure the DC resistance, or display the current through or voltage across a test device ensuring the operator of the real test conditions. Wide Frequency Over 27,000 user programmable test frequencies to fully characterize devices over the range of 20 Hz to 1 MHz. Automatic Test Sequencing For increased productivity and throughput the 1920 can perform up to six different tests in sequence with a single push of the start button. Each test can have different measurement parameters, test conditions and limits. DC Bias Voltage The instruments internal DC bias voltage source, programmable from 0 to 2 V in 1 mV steps, allows capacitors to be tested under real DC bias conditions. Setup Storage/Recall The test operator has the ability to store and recall, from internal memory, up to 30 single test setups and 10 sequential setups (six tests in sequence). The front panel can be locked out, with password protection, to ensure that procedures are run the same way every time. Load Correction Substantially improves instrument accuracy by allowing the operator to specify the value of a known standard, measure it, and apply a correction to ongoing measurements. Programmable Source Impedance The operator is able to set instrument source impedance at 5, 25, 50 or 100 ohms, an important feature when comparing measurements to those made on other testers. Measurement results can vary substantially based solely on the source impedance of the tester being used. Includes power cord, instruction
manual, and calibration certificate. One year warranty. |
Pricing Information |
|
|
QuadTech 1920 LCR Meter |
$4,695 |
|
|
|
Options & Accessories |
|
|
1700-01 Axial/Radial Component Test Fixture |
$265 |
|
|
|
|
1700-02 Axial/Radial Component Test Fixture (Remote) |
$170 |
|
|
|
|
1700-03 Kelvin Clip Leads |
$170 |
|
|
|
|
1700-05 Chip Component Tweezers |
$170 |
|
|
|
|
|
To order, call us at 800-950-3457 or visit us on the web: www.TestEquity.com |