|
|
|
|
||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
|
|---|
Magna-Power Electronics XR Series II DC Power Supplies
Click for Larger Image
|
|
Additional Product Information
Specifications (pdf, 3.1M) >>Operating Manual (pdf, 2.9M) >>
XR Series Controls >>
About Magna-Power Electronics >>
Overview of Current-fed Power Processing >>
Innovative and Scalable
Magna-Power Electronics XR Series combines the best of DC power processing
with microprocessor embedded control. A combination of high and medium frequency
power processing technologies improves response, shrinks package size, and
reduces cost. XR Series power supplies are current fed and are more tolerant
to abusive loads than conventional switching power supplies. This technology
allows the power supply to operate under short-circuit conditions, open-circuit
conditions, and everything in between. XR Series power supplies offer both
master/slave parallel and series operation. This enables two or more power
supplies to be placed in parallel for increased output current or in series
for increased output voltage. With master/slave operation, power supplies operate
at near equal voltage and current. XR Series power supplies can operate as
a voltage source or current source depending on the control settings and load
conditions. If the power supply is operating as a voltage source and the load
increases to a point beyond the current command setting, the power supply automatically
crosses over to current mode control and operates as a current source at that
setting.
Fully Configurable
XR Series power supplies can be configured through the front panel for
different applications. The power supply can be programmed to have its control
functions accessible from the front panel, rear connector, RS-232, optional
GPIB, optional USB, or optional LXI-certified Ethernet communications. Sensing
can be established at the output terminal of the power supply or through a
rear terminal block for sensing at the load. An external interlock can be set
to enable operation only when an external connection is made. Even calibration
has been simplified with front panel access to calibration digital potentiometers.
Isolated External I/O for Automation
Using the rear 37-pin I/O connector, the XR Series power supplies can be
completely controlled and monitored using external signals. The voltage, current,
over voltage trip, and over current trip set points are set by applying a 0-10
Vdc signal. Each diagnostic condition is given a designated pin, which reads
10 Vdc when high. Also, the power supply features an external interlock, which
when enabled, allows the power supply to be tied in with other emergency stop
equipment. All these pins are isolated to earth-ground as standard - no additional
isolation equipment necessary!
Designed for Safety
XR Series power supplies have extensive diagnostic functions - all of which,
when activated, take command to shut down the system. Diagnostic functions
include phase loss, excessive thermal conditions, over voltage trip, over current
trip, fuse clearing, and program line. Program line monitors externally applied
analog set point signals to insure they are within the specified range. Upon
a diagnostic fault condition, main power is disconnected and the diagnostic
condition is latched into memory. Pressing the clear key clears the memory.
All diagnostic functions can be monitored through a rear connector. Furthermore,
control functions can also be set through the rear connector to allow simultaneous
control of one or more XR Series units. XR Series supplies have three levels
of over voltage/current protection: shutdown of controlling insulated gate
bipolar transistors (IGBT's), disconnect of main power, and input fuses. After
an over voltage/current trip condition, the supply must be reset.
XR Version Front Panel
XR models provide stepless analog control from front panel potentiometers.
With a simple configuration change, the power supply can be programmed from
the rear I/O connector or through software on one of the communications bus.
The XR Series has 100 memory states available to program voltage, current,
over voltage trip, over current trip, and time period in software. More
Info >>
XRC Version Front Panel
XRC models only allow control from the rear connector or by RS-232/GPIB/Ethernet
communications. These models are intended for process control applications
where front panel controls and displays are not required or desired. More
Info >>
 Remote
Interface SoftwareThe Remote Interface Software is shipped with all XR Series power supplies. The software provides the user with a quick method to operate a Magna-Power Electronics' power supply under computer control. The Remote Interface Software has six windows: the Virtual Control Panel, Command Panel, Register Panel, Calibration Panel, Firmware Panel, and Modulation Panel. The Virtual Control Panel emulates the front panel of the XR Series power supply, the Command panel programs and reads SCPI commands with user friendly buttons, the Register Panel programs and reads registers, the Calibration Panel enables calibration of the digital potentiometers, the Firmware Panel enables the program stored internal to the power supply to be upgraded, and the Modulation Panel eases programming of modulation parameters. |
|
|
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Input Voltage (Must be specified at
time of order) 3 phase, 3 wire + ground (all models) |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Model Ordering System | ||||||||
| Series | Front Panel | Voltage (Vdc) | - | Current (Adc) | / | Input Voltage | - | Interface Option |
| XR | Blank: Standard Panel C: Computer (Blank) Panel |
See Tables | - | See Tables | / | 208SP 240SP 208 240 380 415 440 480 |
- | USB GPIB Ethernet
|
| Example: XR600-10/208-GPIB | ||||||||
NOTE:
- GPIB and Ethernet are optional and must be specified at time of order.
- Power cords are not included.
Pricing available for sale within USA and Canada. Warranty only applies to customers in the USA and Canada.
|
|
PRICING INFORMATION
|
Magna-Power Electronics XR 2 kW Models DC Power Supplies Specify voltage and current range from tables above. |
TestEquity Price $2,795
|
|
 |
||
|
Magna-Power Electronics XR 4 kW Models DC Power Supplies Specify voltage and current range from tables above. |
TestEquity Price $3,995
|
|
|
|
||
|
Magna-Power Electronics XR 6 kW Models DC Power Supplies Specify voltage and current range from tables above. |
TestEquity Price $4,695
|
|
|
|
||
|
Magna-Power Electronics XR 8 kW Models DC Power Supplies Specify voltage and current range from tables above. |
TestEquity Price $5,795
|
|
|
|
||
|
Magna-Power Electronics XRC 2 kW Models DC Power Supplies Blank front panel. Specify voltage and current range from tables above. |
TestEquity Price $2,695
|
|
|
|
||
|
Magna-Power Electronics XRC 4 kW Models DC Power Supplies Blank front panel. Specify voltage and current range from tables above. |
TestEquity Price $3,895
|
|
|
|
||
|
Magna-Power Electronics XRC 6 kW Models DC Power Supplies Blank front panel. Specify voltage and current range from tables above. |
TestEquity Price $4,595
|
|
|
|
||
|
Magna-Power Electronics XRC 8 kW Models DC Power Supplies Blank front panel. Specify voltage and current range from tables above. |
TestEquity Price $5,695
|
|
|
|
||
OPTIONS & ACCESSORIES
|
Ethernet Internal Ethernet Interface (LXI) |
TestEquity Price $395
|
|
|
|
||
|
GPIB Internal GPIB Interface |
TestEquity Price $595
|
|
|
|
||
|
USB External USB Interface Converter Converts RS-232 interface to USB. |
TestEquity Price $125
|
|
|
|
||
|
485DSS External RS-485 Interface Converter Converts RS-232 interface to RS-485. |
TestEquity Price $175
|
|
|
|
||
|
UID46 Interface Device For Master/Slave Connections |
TestEquity Price $345
|
|
|
|
||
RELATED ITEMS
|
Magna-Power Electronics TS Series III DC Power Supplies 5 kW to 45 kW |
|
|
|
|
Put the experts at TestEquity to work for you. For sales, rentals,
lease quotes, and product availability worldwide, give us a call!