Aim-TTi TGR6000 Synthesized Signal Generator

22308.1 MFG #: TGR6000
$4,560.00 / EA
  • Brand: Aim-TTi
  • Condition: New

QTY
  • Description

    • 10 MHz to 6000 MHz frequency range
    • 10 Hz setability, +/-1 ppm frequency stability
    • Locking to external frequency standard
    • -110 dBm to +7 dBm amplitude, 0.1 dB steps
    • Fast stepping sweep with dwell times down to 10ms
    • List sweep of up to 1000 points of amplitude vs frequency
    • User compensation tables for specific test set-ups
    • Storage for 12 generator set-ups and 16 sweep lists
    • Compact half-rack 2U casing uses minimum bench space
    • Full remote control through RS-232, USB, LAN and GPIB

    The TGR6000 is a low-cost RF signal generator with a maximum frequency of 6GHz. It is intended for CW (carrier wave) applications where modulation is not required, and avoids the costs associated with adding modulations.

    Low phase noise is matched by low leakage, low residual FM and spurii. The internal timebase has a 1ppm stability, and an external frequency reference can be used for higher precision.

    The output amplitude and/or frequency can be swept over the full range of each in a single sweep. The instrument can be set up to perform two types of sweep. The first sweep type is a Step Sweep in which the start and stop conditions are defined, together with the number of points in the sweep, linear or logarithmic spacing between points, and a dwell time at each point.

    The other sweep type is a List Sweep in which up to 1000 points are defined in a list, with the frequency, level and dwell time specified for each point. Both types of sweep can be free run or triggered by a Sweep Trigger from a variety of sources; in addition, a Point Trigger can be defined for each individual step of the sweep. A rear panel SYNC output signal indicates when the output is stable, and can be user-programmed to be high or low.

    The output level can be adjusted to correct for external equipment frequency response using the TRIM function. The TRIM function consists of a user programmable list of up to 100 amplitude adjustment/frequency pairs.

    The instrument provides non-volatile storage for up to 12 instrument setups and up to 16 sweep lists.

    The instrument is remotely controllable via LAN, USB, RS-232 or GPIB.