Keysight N7550A Electronic Calibration Module

26399.6 MFG #: N7550A
$0.00 / EA
  • Condition: New
  • Family Models: N7550A NFF
  • Manufacturer: Keysight

  • Description

    Supported on FieldFox N9923, N991x, N992x, N995x

    • Frequency coverage: from DC to 4 GHz
    • Supports Type N and 3.5 mm connectors
    • Smaller, lighter 2-port ECal module
    • Zero wait time for faster calibration
    • Convenience of ECal with the performance of an economy mechanical kit
    • Three-year warranty

    Electronic calibration (ECal) is a precision, single-connection calibration technique vector network analyzers
    ECal replaces the traditional calibration technique, which uses mechanical standards that require numerous connections to the test ports for a single calibration. With N755xA Series ECal modules, a full one- to two-port calibration can be accomplished with a single connection to the ECal module, resulting in faster and more repeatable calibrations.

    N7550A 2-port ECal to 4 MHz
    The N7550A value-line electronic calibration (ECal) module makes calibration of vector network analyzers fast, easy and accurate. Cut your calibration down to half the time it normally takes using a traditional mechanical cal kit. Simply connect it to your instrument and the firmware does the rest.

    The N7550A Calibration Module support Keysight's FieldFox Handheld Analyzers. This 2-port ECal module supports 3.5 mm connectors or Type N connectors. And, as it's a value-line product you may find it to be cost-effective to replace the module than to have it recertified.

    N755xA Electronic Calibration Modules

    N7550A USB View
    N7550A Bottom (USB) View
    ECal Module Frequency Connector(s)
    N7550A DC-4 GHz Type N and 3.5 mm
    N7551A DC-6.5 GHz Type N and 3.5 mm
    N7552A DC-9 GHz Type N and 3.5 mm
    N7553A DC-14 GHz Type N and 3.5 mm
    N7554A DC-18 GHz Type N and 3.5 mm
    N7555A DC-26.5 GHz 3.5 mm*

    * N7555A Electronic Calibration Module does not support Type N connectors.

    The firmware installed on the instrument is used to control the calibration module, making it a fully integrated solution. The calibration code on the instrument communicates via a USB 2.0 micro-interface and simplifies the calibration to a single connection for a full two-port calibrated measurement.