AMETEK Programmable Power DLM-60-10 DLM Near Linear System Supply, 1U 1/2 Rack, 600 W, 60 V, 10 A

Ametek Sorensen DLM 60-10 Programmable DC Power Supply

The Ametek Sorensen DLM 60-10, part of the DLM 600 Series, is a high-performance, programmable DC power supply delivering up to 600 watts in a compact 1U half-rack form factor. It provides a fully adjustable 0-60 V output and 0-10 A current range, making it ideal for demanding test, measurement, and industrial environments.

Utilizing advanced Zero Voltage Switching (ZVS) technology, a soft-switching power conversion technique, the DLM 60-10 achieves exceptionally low ripple and noise comparable to larger linear power supplies, while maintaining high efficiency and fast transient response.

Its compact design (1.75" height, 8.5" width) supports both rack-mounted and benchtop use, while an intelligent cooling system with front and side air intake and rear/side exhaust enables units to be stacked without spacing for maximum rack density. Variable speed fans adjust based on load and ambient temperature, improving efficiency, reducing acoustic noise, and extending system life. Integrated remote control capabilities (optional RS-232, Ethernet, GPIB) allow seamless integration into automated systems.

Key Specifications & Benefits

• Output Voltage: 0-60 VDC
• Output Current: 0-10 ADC
• Power Output: 600 W
• High Power Density: 600 W in 1U half-rack design
• Low Ripple & Noise: 5 mV rms / 30 mV p-p
• Efficiency: Approximately 84% at full load (typical)
• Line Regulation: 5 mV (0.005% of Vmax + 2 mV)
• Load Regulation: 5 mV (0.005% of Vmax + 2 mV)
• Transient Response: 500 µs recovery time
• Remote Interfaces: optional Ethernet/ LXI, RS-232C, IEEE-488.2
• Analog Programming: 0-5V, 0-10V, or 0-5kΩ
• Expandable Operation: Parallel (up to 4 units) and series capable
• Operating Temperature: 0°C to 50°C (no derating)
• Auto-Ranging Input: 90-264 VAC, single phase
• Display: Two 3 1/2 digit LED

Key Benefits

• Maximizes rack space with compact, high-density design
• Delivers precise, low-noise output for sensitive applications
• Supports automated test environments with multiple interfaces
• Scalable power through series and parallel configurations
• Reliable performance across a wide temperature range

Applications

• Automated test equipment (ATE) systems
• Research and development laboratories
• Industrial electronics testing
• Component and subsystem validation
• Burn-in and reliability testing
• Rack-mounted multi-output systems
• Benchtop engineering and troubleshooting

What's in the Box

• DLM 60-10 DC Power Supply
• Power Cord
• CAlibration Certificate

Frequently Asked Questions

1. What voltage and current does the DLM 60-10 provide?
   The DLM 60-10 provides an adjustable output of 0 to 60 volts and 0 to 10 amps delivering up to 600 watts of power.

2. Can the DLM 60-10 be used in automated test systems?
   Yes, it supports Ethernet (LXI), RS-232, IEEE-488.2 (GPIB), and analog programming, making it ideal for integration into automated environments.

3. Can multiple units be combined for higher output?
   Yes, the power supply supports parallel operation (up to 4 units) and series configurations for scalable voltage and current output.