TPI 270 Clamp-On Tester with Digital Multimeter

Features and Specifications

• Measure motor in-rush current and run current
• Measure temperature differential with relative mode
• Non-contact voltage feature can be used to immediately see if power is being supplied to the 24VAC control circuit of thermostats
• Frequency, Min/Max/Record, Data Hold, and Peak Hold
• Up to 40,000 Microfarads to test run and start capacitors
• 4,000 count display with 41 segment analog bargraph
• Auto & Manual Ranging
• Low Battery Indicator
• Over Range Indication (OL)
• Hi Voltage Indicator(>30V AC/DC)
• Auto Power Off after 30 minutes
• Separate Battery/Fuse Compartment
• Low Ohm Range (400V)
• Amps AC Resolution: 0.01A
• VDC/VAC Resolution: 0.1mV
• DCµA measurement (0.01µA resolution)
• Temperature measurement with 0.1 degree resolution

The TPI 270 with slim jaw and body is ideal for cramped work areas and crowded electrical panels. Its non-contact voltage detection allows you to detect the presence of voltage without contacting the circuit with the test leads.

Note: An adapter is not needed to perform temperature tests with the 270. The 270 accepts K-type thermocouple probes with a sub-mini connector.

What's in the Box

• Standard K-Kype Thermocouple Probe
• Test Lead Set with Alligator Clips (clip-on)
• Soft Carrying Pouch