QA Technology 100-PRP2508X Probe, 0.100 Center, 0.250 Full Stroke, Triad, Extra SF, 100-25 Series

• Conventional probe designed for loaded board testing.
• 0.100 center and 0.250 full stroke probe, part of QA Technology's 100-25 Series.
• Extra Spring Force (SF) made of musical wire material with a 1,000,000 cycle life.
• Triad tip style (#08) provides the highest penetrating pressure for reliable testing on flat or domed test pads.
• Tube material "P" nickel silver/id precious metal clad improves wear properties and offers < 20 mOhms resistance.
• Working temperature range of -55°C to 120°C with lubrication. SS springs can be used up to 204°C without lubrication.

The 100-PRP2508X, part of QA Technology's 100-25 Series, is a conventional probe designed for loaded board testing. At a 0.100" center and a 0.250" stroke, you get extra spring force backed by a 1,000,000-cycle lifespan. A Triad tip (#08) provides the contact geometry you need for reliable testing on flat or domed test pads. Low < 20 mΩ resistance ensures accurate measurements, while metal cladding enhances wear properties. Factory lubrication maximizes cycle life, and QA Technology’s signature angled plunger tail improves biasing for consistent electrical contact. Safe for use between -55°C and 120°C.

Questions and Answers

What is the maximum voltage that QA Technology test probes and sockets can carry?
There is no specific upper voltage limit defined for test probes or socket/termination pins. However, the spacing between probes and the dielectric strength of the probe plate must be evaluated. Probe plate materials that absorb moisture should be avoided. Apply test voltage to the fixture or DUT only after the fixture is engaged and the probes are fully compressed against the DUT. Energizing the probes before they make contact can cause arcing, which may damage or melt the probe tips.

Can QA Probes be used for Hipot testing?
Yes. Hipot testing, short for High Potential testing and also known as a Dielectric Withstanding Voltage (DWV) test, subjects a device to a voltage higher than its normal operating level. The purpose is to confirm that the device’s insulation can withstand this elevated voltage without breaking down, ensuring it provides adequate protection against electrical shock. This method is commonly applied to PCBs, transformers, electric motors, finished appliances, cables, and other wired or wireless assemblies.