• Addition Curing
• BfR compliant
• Dry surface
• FDA compliant
• Flowable
• Food-contact
• No chemical shrinkage
• Resistance against epoxy resins
• Resistance against polyester
• Resistance against PU
• Two-component
• Good flow
• Fast and non-shrink cure at room temperature which can be accelerated considerably by the application of heat
• High Shore A hardness (approx. 55)
• High tear strength
• Long-term stability of the vulcanizate's mechanical properties
• Outstanding resistance to common casting resins

Pourable, addition-curing, two-component silicone rubber that vulcanizes at room temperature.

Due to its outstanding resistance to casting resins as well as its superior mechanical properties ELASTOSIL M 4670 A is perfectly suitable for all molds of models with undercuts that are to be reproduced in casting resins, and a certain inherent rigidity of the molds is required.

As a high-Shore addition-curing RTV-2 silicone rubber that cures without undergoing dimensional shrinkage, ELASTOSIL M 4670 A is also extremely suitable for casting all other common reproduction materials, particularly if absolutely accurate copies of models with undercuts are required.

The 'Best use before end' date of each batch is shown on the product label. Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.