Master Network Series: Wired network installation and maintenance must also evolve as networks evolve. The MTA1000A is customized easily for every measurement by changing modules.

MU100090B High Performance GNSS Disciplined Oscillator - Sync Module

Commissioning and Verifying Mobile Backhaul
The MU100090B is an atomic-clock oscillator module providing reference timing to test network synchronization. It supports GPS, GLONASS, Galileo, Beidou, and QZSS as a reference timing source.

Features:

• Time Error Measurement: Measures phase difference from 1 PPS/PTP Packet nming based on GNSS signal
• Evaluation of PTP/SyncE synchronized network
  • At the network edge, the MU100090B emulates a slave clock to monitor timing distributed to the network.- max|TE| (absolute Time Error), cTE (Constant Time Error), dTE (Dynamic Time Error), wander (MTIE, TDEV) and pktSelectedTE as metrics of phase/time synchronization.
  • One-way delay (OWD) is measured to evaluate PDV and FPP.
  • SyncE Wander by TIE, MTIE, TDEV metrics
• SyncE Wander Measurement
• Protocol Functional Test
  • After a PTP session is established, the tester displays various status conditions announced from the network and measures message rates.
  • Supported Profiles: G.8265.1, G.8275.1, G.8275.2, SMPTE2059-2 and customized parameters.
• Ethernet One-Way Latency Measurement: Synchronizes two MT1000A units for one-way high-accuracy latency measurements between separate localities

Specs:

• Internal Oscillator: Rubidium atomic clock
• External Clock Output 10 MHz: Connector: BNC Jack/50 Ohms (nom.); Level: TTL
• 1PPS Sync Input:
  • Usage: Synchronize the internal oscillator with this 1PPS, ITU-T G.703
  • Connector: BNC Jack/50 Ohms (nom.)
  • Level: TTL
  • Input Frequency Range: ±10 ppb
• 1PPS Reference Output:
  • Connector: BNC Jack/50 Ohms (nom.)
  • Level: TTL
  • Polarity: Positive/Negative
• Antenna Input:
  • Connector: SMA Jack/50 Ohms (nom.)
  • Feeding Antenna: Off/+3.5 V/5 V Slectable, 50 mA max.
• AUX Output:
  • Usage: Provide MT1000A with ToD (NMEA0183) with J1705 (AUX interface adaptor)
  • Connector: D-SUB 9 pin
• Supported Signal:
  • GPS L1C/A, L2C
  • QZSS L1C/A, L2C
  • Beidou B1I, B2I
  • GLONASS L1OF, L2OF
  • Galileo E1B/C, E5B
  • GPS L2C, QZSS L2C, GLONASS L2OF, Galileo E5B, Beidou B2I are available after MU100090B-001 is installed.
  • QZSS, GLONASS, Galileo, Beidou are available after MU100090B-002 is installed.
• Number of Receivable Channel: 50 channel
• Time Accuracy to GNSS Time:
  • Without MU100090B-001: ±45 ns rms*
  • With MU100090B-001: ±10 ns rms*

Standard Accessories: AUX Conversion Adaptor, GNSS Antenna, BNC Cable (20 cm) × 2, Tripod for GNSS Antenna